It’s not actually an island it’s a dining room table, but that didn’t sound nearly as festive.

So we received this table from a friend of ours. Who had previously got it from another friend of ours, and by the time that “first” owner had it the table was already second hand. So with this project I had the opportunity to do some serious archaeology.

When we received the chairs they had a lovely teal fabric on them. I wasn’t opposed to the teal but they were a little sun faded and stained from years of use and the cushioning was breaking down. I knew our friend hadn’t replaced the cushioning when she reupholstered instead opting just to recover the existing fabric. Which truth be told, is the only kind of upholstery work I’ve ever done.

So out the staples came to reveal what our other friend had for her chair cushions. Each chair a different pattern. We had actually considered doing this, all the same color scheme just different patterns, but eventually I found a bargain on some fabric I loved and just couldn’t pass it up. This is very much her style and her current dining setup has all different chairs not just different patterns on the same chairs.

So off that fabric came…. And what a surprise. The misfits were not the last layer. There was the most boring khaki color you have ever seen underneath.

So off that came as well. To reveal the horrors…

Turns out all of that work was for nothing, the seat bases were delaminating. Also the actual cushioning material was made out of an old egg crate mattress pad. Which was slightly horrifying. That didn’t matter as we planned on replacing that anyway. But the wood for the seats would have to be replaced.

Luckily one had already been replaced, two owners back if the fabric strata are to be believed. So that one was excellent to use as a template. We simply traced it out on our new sheet of plywood, used the table saw to rip it down and a jig saw to round the corners. And hey presto! New seats.

Next on to the foam padding, once again using the already refurbished one as a template.

Finally after the couple of bumps in the road (and a coffee cup full of staples… that could have made for a bad morning) we could get down to upholstery.

I’ve recovered a few things before, like I said I’ve never done it from scratch. The only real difference I found is that because you’re pulling on new foam and placing tension on the fabric you can if you’re not careful run into puckering. As long as you start from the middle, alternate sides, work towards the corners and be careful how much tension you put on the fabric you shouldn’t have too much trouble.

And always remember that if you do get puckering you can always pull out and replace staples to relieve it, mistakes are going to happen and they aren’t permanent in this case. I had to pull out quite a few on my first couple of chairs before I got the hang of it.

When all was said and done, we had lovely and oh so comfortable new seat cushions.

We also had a pile of old fabric and a coffee cup full of staples.

Also note I did not in any way try to center my pattern… do yourself a favor and do the same if you are trying this for the first time, from what I understand it’s not the easiest thing in the world

Next up we will be painting the chairs… wooo hooo!