I studied graphic design for four years and used to work in a sign shop. This, by no means has made me a master at the art of hand lettering. Not to fear, there is a work around for this.

Those dreaded Target bins suckered me in again with an absolutely darling (does anyone say darling anymore) chalkboard easel and I’ve been sitting here debating what to put on it. Well, I’ll give you a hint at a future blog post as I am working on a massive cross stitch project. I decided I would open up Word and just type up something appropriate for my easel to motivate me through that particular project. Not that I seem to need much help.

I then just printed it out and made sure everything was the appropriate size for the piece. Then I took a piece of chalk and rubbed it on the back of the paper anywhere there was lettering. Essentially making carbon paper (only, obviously… chalk paper?)… I don’t think anyone uses carbon paper anymore and I wouldn’t even know where to get such a thing, but it can make things a bit easier if you’re attempting “hand lettering”… The work around for carbon paper is just rubbing graphite on the back of the paper.

Then you just place your piece of paper onto your chalkboard where you are going to want the lettering and secure it with tape. Print side up, chalk side down. Then trace over the letters with a pen or pencil or stylus, anything to apply pressure to transfer the chalk from the back of the paper onto the chalkboard.

After I did all that I did go over the transfer image with a sharp piece of chalk just to make the lettering starker. You could go over it with a chalk marker but, keep in mind that the markers usually don’t wash off chalkboards or chalk paint very well.

Lastly I just did a little bit of embellishment. A little washi tape around the edges to act as a frame/border

And a few designs here and there to dress it up a bit.

Hopefully that will motivate me to get this project done a little faster.